1、 Check the feeding port
The reason why the disc feeder does not discharge may be due to blockage in the feeding port. Therefore, the first step is to check whether the feeding port is clean and unobstructed. Inspection method: Turn off the feeder and open the feeding port. Use an air compressor or other tool to clean the residue inside the feeding port, and then reassemble the feeding port.
2、 Replacing the disc
The disc of the disc feeder may deform or wear after being used for a period of time, resulting in failure to discharge. At this point, a new disc needs to be replaced. Replacement method: First, turn off the feeder, remove the ingredient tray, disassemble the original disc, install according to the specifications of the new disc, and then start the feeder after assembly to check if it is working properly.
3、 Adjusting the distance between the feeding chute
If the disc feeder is too far away from the batching tank, the material cannot fully fill the feeding tank, resulting in no discharge. At this point, the distance between the disc and the feeding groove can be adjusted appropriately. Specific operation method: First, turn off the feeder, open the feeding groove, adjust the distance of the feeding groove, and adjust it to the appropriate position.
4、 Check if the motor is faulty
If the motor of the disc feeder malfunctions, it can also lead to situations where the material cannot be discharged. Therefore, after ruling out the above reasons, the motor should be checked for normal operation. Inspection method: First, turn off the feeder and check whether the motor rotor shaft rotates normally. At the same time, check whether the cable is tightly inserted and whether the power supply is connected properly.
In summary, there are various reasons why the disc feeder does not discharge, and it is necessary to analyze the reasons based on the actual situation and take corresponding measures to solve them. The above methods are for reference only. During the specific operation process, it is necessary to strictly follow the operating procedures to ensure safe production.
